Cisco Systems SFS 3012 User Manual
20
Read the Cautionary Statements
Refer to the
before you install
your Topspin 360.
Prepare the Physical Environment for the
Topspin 360
Topspin 360
•
Ground yourself using an approved ground wrist-strap.
•
Make sure you have the right cables and sufficient ventilation.
•
Unpack the Topspin 360 package.
CAUTION: Do not lift the Topspin 360 by the front and back (bezel end and service end). Lift the
unit by the sides to prevent damage.
unit by the sides to prevent damage.
•
Prepare a management workstation, such as a PC running terminal-emulation software, and a
straight-through M/F DB-9 serial cable (included).
straight-through M/F DB-9 serial cable (included).
Install Topspin 360 Components
Install any gateway and switch card modules before you rack the Topspin 360, when possible. However,
you may change modules while the Topspin 360 chassis is still in the rack.
you may change modules while the Topspin 360 chassis is still in the rack.
For details regarding installing the switch cards, refer to
.
For details regarding installing power supplies and fans, refer to
and
.
For details regarding installing Fibre Channel gateways, refer to the Fibre Channel Gateway User
Guide.
Guide.
For details regarding installing Fibre Channel gateways, refer to the Ethernet Gateway User Guide.
Rack the Topspin 360
To mount the Topspin 360 in a rack, perform the following steps:
1. Open the Topspin box.
2. Remove the chassis, rack brackets, CD-ROM, parts bag, and documentation.
1. Open the Topspin box.
2. Remove the chassis, rack brackets, CD-ROM, parts bag, and documentation.
CAUTION: Do not lift the 360 chassis by the front (bezel end) and back (service end). Lift the
unit by the sides to prevent damage.
unit by the sides to prevent damage.
3. Place the chassis on a secure, clean surface.
4. Open the plastic bag that contains the mounting hardware.
5. Verify that the rack provides sufficient clearance for the Topspin 360.
6. Loosen the nuts on the sides of the rack brackets, then adjust the length of your brackets to fit your
4. Open the plastic bag that contains the mounting hardware.
5. Verify that the rack provides sufficient clearance for the Topspin 360.
6. Loosen the nuts on the sides of the rack brackets, then adjust the length of your brackets to fit your
rack. Tighten the bracket screws when the brackets fit the rack. You can extend the brackets to 29
inches or contract them to 24 inches.
inches or contract them to 24 inches.