Sony SHAKE5 Manual

model name [SHAKE-5]

[4-462-816-12(1)] GB

filename[D:\NORM'S JOB\SONY HA\SO130030\SHAKE-5 (PMRF 
02)\4462816121_GB\080ADD.fm]

masterpage:Left

Perform the following procedure to 
protect the disc mechanism.
Use the buttons on the unit to perform this 
operation.

Press "/1 to turn on the system.

Press CD.

Remove the disc.
Press Z OPEN/CLOSE to open and 
close the disc tray.
Wait until “NO DISC” appears in the 
display panel.

Hold down CD and FLANGER for 
3 seconds. 
“MECHA LOCK” appears in the 
display panel.

Unplug the power cord.

• Before playing, wipe the disc with a cleaning 

cloth from the center outward to the edge.

• Do not clean discs with solvents, such as 

benzine, thinner, or commercially available 
cleaners or anti-static spray intended for vinyl 
LPs.

• Do not expose discs to direct sunlight or heat 

sources such as hot air ducts, nor leave it in a 
car parked in direct sunlight.

• Completely disconnect the power cord (mains 

lead) from the wall outlet (mains) if it is not 
going to be used for an extended period of 
time. When unplugging the unit, always grip 
the plug. Never pull the cord itself.

• Should any solid object or liquid get into the 

system, unplug the system, and have it 
checked by qualified personnel before 
operating it again.

• (For customers in United States only)

One blade of the plug is wider than other for 
the purpose of safety and will fit to the wall 
outlet only one way. If you are unable to insert 
the plug fully into the outlet, contact your 
dealer.

• AC power cord must be changed only at the 

qualified service shop.

• Do not place the system in an inclined 

position or in locations that are extremely hot, 
cold, dusty, dirty, or humid or lacking 
adequate ventilation, or subject to vibration, 
direct sunlight or a bright light.

• Be careful when placing the unit or speakers 

on surfaces that have been specially treated 
(for example, wax, oil, polish) as staining or 
discoloration of the surface may result.

• If the system is brought directly from a cold to 

a warm location or is placed in a very damp 
room, moisture may condense on the lens 
inside the unit, and cause the system to 
malfunction. In this situation, remove the 
disc, and leave the system turned on for about 
an hour until the moisture evaporates.

• Heat buildup on the unit during operation is 

normal and is not a cause for alarm.

• Do not touch the cabinet if it has been used 

continuously at a high volume because the 
cabinet may have become hot.

• Do not obstruct the ventilation holes.

This speaker system is not magnetically 
shielded, and the picture on nearby TV sets may 
become magnetically distorted. In this situation, 
turn off the TV, wait 15 to 30 minutes, and turn 
it back on. If there is no improvement, move the 
speakers far away from the TV.

Clean this system with a soft cloth slightly 
moistened with a mild detergent solution.
Do not use any type of abrasive pad, scouring 
powder, or solvent, such as thinner, benzine, 
or alcohol.

On Bluetooth Communication

• Bluetooth devices should be used within 

approximately 10 meters (33 feet) 
(unobstructed distance) of each other. The 
effective communication range may become 
shorter under the following conditions.
– When a person, metal object, wall or other 

obstruction is between the devices with a 
Bluetooth connection

– Locations where a wireless LAN is installed
– Around microwave ovens that are in use
– Locations where other electromagnetic 

waves occur