Cisco Systems SRW248G4PK9NA User Manual
Smartport
Default Configuration
Cisco Small Business 300 Series Managed Switch Administration Guide
156
10
Default Configuration
Smartport is always available. By default, Auto Smartport is enabled by Auto
Voice VLAN, relies on both CDP and LLDP to detect attaching device's Smartport
type, and detects Smartport type IP phone, IP phone + Desktop, Switch, and
Wireless Access Point.
Voice VLAN, relies on both CDP and LLDP to detect attaching device's Smartport
type, and detects Smartport type IP phone, IP phone + Desktop, Switch, and
Wireless Access Point.
See
for a description of the voice factory defaults.
Relationships with Other Features and Backwards
Compatibility
Compatibility
Auto Smartport is enabled by default and may be disabled. Telephony OUI cannot
function concurrently with Auto Smartport, and Auto Voice VLAN. Auto Smartport
must be disabled before enabling Telephony OUI.
function concurrently with Auto Smartport, and Auto Voice VLAN. Auto Smartport
must be disabled before enabling Telephony OUI.
NOTE
When upgrading from a firmware version that does not support Auto Smartport to
a firmware level that supports Auto Smartport, the Auto Voice VLAN is disabled
after the upgrade. If Telephony OUI was enabled before the upgrade, then Auto
Smartport is disabled after the upgrade, and Telephony OUI remains enabled.
a firmware level that supports Auto Smartport, the Auto Voice VLAN is disabled
after the upgrade. If Telephony OUI was enabled before the upgrade, then Auto
Smartport is disabled after the upgrade, and Telephony OUI remains enabled.
Common Smartport Tasks
This section describes some common tasks to setup Smartport and Auto
Smartport.
Smartport.
Workflow1: To globally enable Auto Smartport on the device, and to
configure a port with Auto Smartport, perform the following steps:
configure a port with Auto Smartport, perform the following steps:
STEP 1
To enable the Auto Smartport feature on the device, open the Smartport >
Properties page. Set Administrative Auto Smartport to Enable or Enable by Voice
VLAN.
Properties page. Set Administrative Auto Smartport to Enable or Enable by Voice
VLAN.
STEP 2
Select whether the device is to process CDP and/or LLDP advertisements from
connected devices.
connected devices.
STEP 3
Select which type of devices are to be detected in the Auto Smartport Device
Detection field.
Detection field.