Cisco Systems SRW248G4PK9NA User Manual

Viewing Memory Logs

31

Cisco Small Business 300 Series Managed Switch Administration Guide 

-

Link Local—The IPv6 address uniquely identifies hosts on a single 
network link. A link local address has a prefix of FE80, is not routable, and 
can be used for communication only on the local network. Only one link 
local address is supported. If a link local address exists on the interface, 
this entry replaces the address in the configuration.

-

Global—The IPv6 address is a global Unicast IPV6 type that is visible and 
reachable from other networks.

•

Link Local Interface—Select the link local interface (if IPv6 Address Type 
Link Local is selected) from the list. 

•

Log Server IP Address/Name—Enter the IP address or domain name of the 
log server.

•

UDP Port—Enter the UDP port to which the log messages are sent.

•

Facility—Select a facility value from which system logs are sent to the 
remote server. Only one facility value can be assigned to a server. If a second 
facility code is assigned, the first facility value is overridden.

•

Description—Enter a server description.

•

Minimum Severity—Select the minimum level of system log messages to 
be sent to the server. 

Click Apply. The Add Remote Log Server page

 

closes, the SYSLOG server is 

added, and the Running Configuration file is updated.

The device can write to the following logs:

•

Log in RAM (cleared during reboot).

•

Log in Flash memory (cleared only upon user command). 

You can configure the messages that are written to each log by severity, and a 
message can go to more than one log, including logs that reside on external 
SYSLOG servers.