Pelco C1528M-F User Manual

 

10

C1528M-F (6/05)

 

The CM6800E features easy programming through on-screen menus or the Windows

 

®

 

-based CM6800-MGR software package. 

 

 Programming menus are provided in English, French, German, Italian, Polish, Portuguese, Russian, and 

Spanish.

 

Up to 16 keyboards from the KBD100/200A/300A Series and 2 keyboards from the KBD960/KBR960 Series can be connected to the CM6800E. 
Camera positioning can be programmed and controlled from the KBD200A/300A (in “6800 Mode” only) and KBD960/KBR960 Series keyboards. 
Refer to 

 

 for keyboard descriptions.

 

You can program the CM6800 with the KBD200A/300A keyboard while in “CM6800 Mode” only (if you use “CM6800 ASCII Mode,” you 

can control the CM6800 switcher, but you cannot program it).

 

The CM6800E features the following programmed operations:

A 

 

 allows operators to see a routine of 72 camera views on any system monitor over and over again. The sequence can be operated 

automatically or manually. A 

 

, allows an operator to run a sequence from an individual monitor without entering the 

password-protected programming menus. A 

 

 is a sequence of commands or steps. When a macro is run, the steps programmed into that 

macro are performed. Macros can be operated automatically or manually. Automatic operation can be based on specific times or dates. Macros 
can also be triggered by alarms.

The following operations are available only with positionable cameras controlled by KBD200A/KBD300A or KBD960/KBR960 keyboards:

A 

 

 allows operators to direct a PTZ (camera positioning system) to move to a predetermined scene on keyboard command or as a 

result of an alarm. In addition, a preset can place a descriptive title on the monitor screen. The number of presets available is determined 
by the camera positioning system.

With a 

 

 operators can program a camera positioning system to move around its viewing area in a repeating pattern. The number 

and time length of patterns varies with different positioning systems.

A 

 

 is a user-defined, physical location to which (1) a label is attached and (2) a camera is associated. When the associated camera is 

panned through or remains within this defined zone, the zone label appears on the monitor.

 

The CM6800E interfaces with the following:

•

Coaxitron

 

®

 

 standard mode (15-bit) and extended mode (32-bit) protocol receivers

•

Pelco’s D and P protocol receivers (RS-422)

•

Pelco’s M protocol devices (RS-485)

 

The CM6800E provides the following ways to restrict system access:

•

Camera to Monitor: Cameras can be assigned to specific monitors for viewing. 

•

Keyboard to Monitor: Keyboards can be assigned to control specific monitors. 

•

Camera to Keyboard: Keyboards can be assigned either full control or view-only access to specific cameras (no PTZ control).

The CM6800E provides eight levels of 

 

 control. Each level defines the ability of a keyboard to control a camera positioning system 

(KBD200A/KBD300A or KBD960/KBR960 only) and to access programming screens.