Pelco C1528M-F User Manual
40
C1528M-F (6/05)
Programming the CM6800E
The CM6800E is shipped from the factory with default programming settings. If the defaults are acceptable, the CM6800E can be operated
without any user programming. However, you may want to program the following basic system settings:
without any user programming. However, you may want to program the following basic system settings:
•
Time and date
•
Camera titles
•
PTZ control via hardwire data connections
•
Alarm contacts
Alarms must be enabled before they are functional.
Alarms must be enabled before they are functional.
•
Access
All access is set to YES by factory default.
All access is set to YES by factory default.
•
Communication ports
To connect remote keyboards as shown in the Quick Start Guide, change the settings for Port 7 or 8.
To connect remote keyboards as shown in the Quick Start Guide, change the settings for Port 7 or 8.
Pelco provides two options for programming the CM6800E to your specifications:
•
Password-protected, on-screen programming screens accessible directly from the Matrix Switcher
•
PC-based CM6800-MGR software
Refer to the CM6800-MGR Quick Start Guide for instructions on accessing and using this software to program your system.
NOTE: Pelco strongly recommends uploading your programming settings to the CM6800-MGR to save settings in the event of an
accidental reset.
accidental reset.
The CM6800E allows system programming from only one monitor at a time. If programming from the CM6800-MGR is sent to the CM6800E at
the same time that you are programming from a monitor screen, the system will exit the on-screen programming function.
the same time that you are programming from a monitor screen, the system will exit the on-screen programming function.
CM6800E PROGRAMMING MODE
1. If you have not already done so, select the monitor (KBD960/KBR960: if the Camera menu appears, press
to exit).
2. Press the PGM key (or select
on the KBD960/KBR960). The Password screen appears.
Note that on the KBD960/KBR960 you must first select
and
. Then enter the Define PIN (Default: 1234), and select
.
NOTE: When using the CM6800E as a satellite device in a CM9760 system, you can access the CM6800E programming screens from the
CM9760-KBD keyboard if you are viewing a camera controlled by the CM6800E. Refer to the Using the CM6800E as a Satellite Device in a
CM9740/CM9760 System section in the Appendix.
CM9760-KBD keyboard if you are viewing a camera controlled by the CM6800E. Refer to the Using the CM6800E as a Satellite Device in a
CM9740/CM9760 System section in the Appendix.
Figure 31. CM6800E Password Screen
PGM
DEF
MENU
PELCO VIDEO SWITCHER
MODEL CM6800E
PASSWORD TO MAIN MENU
*******
SCRATCHPAD SEQUENCE
RETURN
MACRO STATUS VIEW