DELL S6000-ON User Manual

• ipv6 nd ra-lifetime — Set IPv6 Router Advertisement Lifetime
• ipv6 nd reachable-time — Set advertised reachability time
• ipv6 nd retrans-timer — Set NS retransmit interval used and advertised in RA
• ipv6 nd suppress-ra — Suppress IPv6 Router Advertisements
• ipv6 ad <ipv6-address> — IPv6 Address Detection
• ipv6 ad autoconfig — IPv6 stateless auto-configuration
• ipv6 address <ipv6-address> — Configure IPv6 address on an interface

NOTE: The command line help still displays relevant details corresponding to each of these 
commands. However, these interface range or interface group commands are not supported when 
Management VRF is configured.

Configuring a Static Route

To configure a static route, perform the following steps:

Task

Command Syntax

Command Mode

Configure a static route that 
points to a management 
interface.

management route ip-
address mask 
managementethernet 

ormanagement route ipv6-
address prefix-length 
managementethernet

NOTE: You can also have 
the management route to 
point to a front-end port in 
case of the management 
VRF. For example: 

management route 2::/64 te 

0/0.

CONFIGURATION

To configure a static entry in the IPv6 neighbor discovery, perform the following steps:

Task

Command Syntax

Command Mode

Configure a static neighbor.

ipv6 neighbor vrf 
management 1::1 
tengigabitethernet 1/1/1 
xx:xx:xx:xx:xx:xx 

CONFIGURATION

Sample VRF Configuration

The following configuration illustrates a typical VRF set-up.

1016

Virtual Routing and Forwarding (VRF)