DELL S6000-ON User Manual
•
•
For more information about Layer-3 interfaces, refer to
Applying an IP ACL
To apply an IP ACL (standard or extended) to a physical or port channel interface, use the following
commands.
commands.
1.
Enter the interface number.
CONFIGURATION mode
CONFIGURATION mode
interface interface slot/port
2. Configure an IP address for the interface, placing it in Layer-3 mode.
INTERFACE mode
ip address ip-address
3. Apply an IP ACL to traffic entering or exiting an interface.
INTERFACE mode
ip access-group access-list-name {in} [implicit-permit] [vlan vlan-range |
vrf vrf-range]
vrf vrf-range]
NOTE: The number of entries allowed per ACL is hardware-dependent. For detailed
specification about entries allowed per ACL, refer to your line card documentation.
specification about entries allowed per ACL, refer to your line card documentation.
4. Apply rules to the new ACL.
INTERFACE mode
ip access-list [standard | extended] name
To view which IP ACL is applied to an interface, use the show config command in INTERFACE mode, or
use the show running-config command in EXEC mode.
Example of Viewing ACLs Applied to an Interface
use the show running-config command in EXEC mode.
Example of Viewing ACLs Applied to an Interface
Dell(conf-if)#show conf
!
interface TenGigabitEthernet 1/1/1
ip address 10.2.1.100 255.255.255.0
ip access-group nimule in
no shutdown
Dell(conf-if)#
To filter traffic on Telnet sessions, use only standard ACLs in the access-class command.
120
Access Control Lists (ACLs)