DELL S6000-ON User Manual

Secure Shell (SSH) Over an IPv6 Transport

Dell Networking OS supports both inbound and outbound SSH sessions using IPv6 addressing. Inbound 
SSH supports accessing the system through the management interface as well as through a physical 
Layer 3 interface.
For SSH configuration details, refer to the Security chapter in the Dell Networking OS Command Line 
Interface Reference Guide.

Configuration Tasks for IPv6

The following are configuration tasks for the IPv6 protocol.

•

•

•

•

•

•

•

Adjusting Your CAM-Profile

Although adjusting your CAM-profile is not a mandatory step, if you plan to implement IPv6 ACLs, adjust 

your CAM settings.
The CAM space is allotted in FP blocks. The total space allocated must equal 13 FP blocks. There are 16 
FP blocks, but the System Flow requires three blocks that cannot be reallocated.

You must enter the ipv6acl allocation as a factor of 2 (2, 4, 6, 8, 10). All other profile allocations can use 
either even or odd-numbered ranges.

The default option sets the CAM Profile as follows:

• L3 ACL (ipv4acl): 6
• L2 ACL(l2acl): 5
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 1
• L2 QoS (l2qos): 1

To have the changes take effect, save the new CAM settings to the startup-config (write-mem or copy 
run start) then reload the system for the new settings.

• Allocate space for IPV6 ACLs. Enter the CAM profile name then the allocated amount.

CONFIGURATION mode

cam-acl { ipv6acl }

464

IPv6 Routing