DELL S6000-ON User Manual
NOTE: IPv6 and OSPFv3 do not support Multi-Process OSPF. You can only enable a single OSPFv3
process.
process.
Set the time interval between when the switch receives a topology change and starts a shortest path first
(SPF) calculation.
(SPF) calculation.
timers spf delay holdtime
Example
Example
Dell#conf
Dell(conf)#ipv6 router ospf 1
Dell(conf-ipv6-router_ospf)#timer spf 2 5
Dell(conf-ipv6-router_ospf)#
Dell(conf-ipv6-router_ospf)#show config
!
ipv6 router ospf 1
timers spf 2 5
Dell(conf-ipv6-router_ospf)#
Dell(conf-ipv6-router_ospf)#end
Dell#
Enabling IPv6 Unicast Routing
To enable IPv6 unicast routing, use the following command.
• Enable IPv6 unicast routing globally.
CONFIGURATION mode
ipv6 unicast routing
Assigning IPv6 Addresses on an Interface
To assign IPv6 addresses to an interface, use the following commands.
1.
Assign an IPv6 address to the interface.
CONF-INT-type slot/port mode
CONF-INT-type slot/port mode
ipv6 address ipv6 address
IPv6 addresses are normally written as eight groups of four hexadecimal digits; separate each group
by a colon (:).
by a colon (:).
The format is A:B:C::F/128.
2. Bring up the interface.
CONF-INT-type slot/port mode
no shutdown
664
Open Shortest Path First (OSPFv2 and OSPFv3)