DELL S6000-ON User Manual
Enabling Layer 2 Protocol Tunneling
To enable Layer 2 protocol tunneling, use the following command.
1.
Verify that the system is running the default CAM profile. Use this CAM profile for L2PT.
EXEC Privilege mode
EXEC Privilege mode
show cam-profile
2. Enable protocol tunneling globally on the system.
CONFIGURATION mode
protocol-tunnel enable
3. Tunnel BPDUs the VLAN.
INTERFACE VLAN mode
protocol-tunnel stp
Specifying a Destination MAC Address for BPDUs
By default, Dell Networking OS uses a Dell Networking-unique MAC address for tunneling BPDUs. You
can configure another value.
To specify a destination MAC address for BPDUs, use the following command.
• Overwrite the BPDU with a user-specified destination MAC address when BPDUs are tunneled across
the provider network.
CONFIGURATION mode
CONFIGURATION mode
protocol-tunnel destination-mac
The default is 01:01:e8:00:00:00
Setting Rate-Limit BPDUs
CAM space is allocated in sections called field processor (FP) blocks.
There are a total of 13 user-configurable FP blocks. The default number of blocks for L2PT is 0; you must
allocate at least one to enable BPDU rate-limiting.
To set the rate-lime BPDUs, use the following commands.
To set the rate-lime BPDUs, use the following commands.
1.
Create at least one FP group for L2PT.
CONFIGURATION mode
CONFIGURATION mode
cam-acl l2acl
For details about this command, refer to
2. Save the running-config to the startup-config.
EXEC Privilege mode
copy running-config startup-config
Service Provider Bridging
855