DELL S6000-ON User Manual
Sample Configuration for a VLT Proxy Gateway
• The above figure shows a sample VLT Proxy gateway scenario. There are no diagonal links in the
square VLT connection between the C and D in VLT domain 1 and C1 and D1 in the VLT domain 2.
This causes sub-optimal routing with the VLT Proxy Gateway LLDP method. For VLT Proxy Gateway to
work in this scenario you must configure the VLT-peer-mac transmit command under VLT
Domain Proxy Gateway LLDP mode, in both C and D (VLT domain 1) and C1 and D1 (VLT domain 2).
This behavior is applicable only in the LLDP configuration and not required in the static configuration.
Sample Configuration
Sample Configuration
Dell(conf-vlt-domain)#proxy-gateway lldp
Dell(conf-vlt-domain-pxy-gw-lldp)#vlt-peer-mac transmit
• Assume the inter-chassis link (ICL) between C1 and D1 is shut and if D1 is the secondary VLT, one half
of the inter DC link goes down. After VM motion, if a packet reaches D2 with the destination MAC
942
VLT Proxy Gateway