DELL PC6224F User Manual
Denial of Service Commands
1127
Default Configuration
ICMP Redirect messages are enabled by default.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan10)#ip redirects
ipv6 icmp error-interval
Use the icmp error-interval command to limit the rate at which ICMP error
messages are sent. The rate limit is configured as a token bucket with two
configurable parameters: Burst-size and burst interval. Use the “no” form of
this command to return burst-interval and burst-size to their default values.
To disable ICMP rate limiting, set burst-interval to zero.
Syntax
ipv6 icmp error-interval
burst-interval [burst-size]
no ipv6 icmp error-interval
•
burst-interval — How often the token bucket is initialized (Range:
0–2147483647 milliseconds).
•
burst-size — The maximum number of messages that can be sent during a
burst interval (Range: 1–200).
Default Configuration
Rate limiting is enabled by default.
The default burst-interval is 1000 milliseconds.
The default burst-size is 100 messages.
The default burst-interval is 1000 milliseconds.
The default burst-size is 100 messages.