DELL PC6224F User Manual

sFlow Commands

There are no pollers configured by default.
The default poll interval is 0.

Interface Configuration (Ethernet) mode

This command has no user guidelines.

console(config-if-1/g2)#sflow 1 polling 6055

Use the sflow sampling command to enable a new sflow sampler instance for 

this data source if rcvr_idx is valid. Use the “no” form of this command to 

reset sampler parameters to the default.

sflow 

rcvr-index sampling ethernet  interfaces sampling-rate [size]

no sflow 

rcvr-index sampling ethernet interfaces

•

rcvr-index—The sFlow Receiver for this sFlow sampler to which flow 

samples are to be sent.  If no receiver is configured, then no packets will be 

sampled.  Only active receivers can be set.  If a receiver expires, then all 

samplers associated with the receiver will also expire.  (Range: 1–8).

•

interfaces — The list of interfaces to poll.

•

sampling-rate—The statistical sampling rate for packet sampling from this 

source.  A sampling rate of 1 counts all packets.  A rate of 0 disables 

sampling.  A value of n means that out of n incoming packets, 1 packet will 

be sampled.  (Range: 1024–65536).

•

size—The maximum number of bytes that should be copied from the 

sampler packet (Range: 20–256 bytes).