DELL PC6224F User Manual

Address Table Commands

In this example, the bridge tables are cleared.

console#clear bridge

Use the port security command in Interface Configuration mode to disable 

the learning of new addresses on an interface. To enable new address learning, 

use the no form of the port security command.

port security [discard] [trap 

seconds]

• discard — Discards frames with unlearned source addresses. This is the 

default if no option is indicated.

•

seconds — Sends SNMP traps and defines the minimal amount of 

time in seconds between two consecutive traps. (Range: 1–1000000)

Disabled

—

No port security

Interface Configuration (Ethernet, Port-channel) mode

When port security is enabled on an interface, all dynamic entries learned up 

to that point are flushed, and new entries can be learned only to the limit set 

by the port security max command. The default limit is 100 dynamic MAC 

addresses.