DELL PC6224F User Manual
278
Dynamic ARP Inspection Commands
Example
console(config)#ip arp inspection filter tier1 vlan 2-
10 static
console(config)#ip arp inspection filter tier1 vlan
20-30
ip arp inspection limit
Use the ip arp inspection limit command to configure the rate limit and
burst interval values for an interface.
Configuring ‘none’ for the limit means the interface is not rate limited for
Configuring ‘none’ for the limit means the interface is not rate limited for
Dynamic ARP Inspection.
NOTE: The maximum pps value shown in the range for the rate option might be
more than the hardware allowable limit. The user needs to understand the box
performance and configure the maximum rate pps accordingly.
Syntax
ip arp inspection limit {none | rate
pps [burst interval seconds]}
no ip arp inspection limit
• none — To set no rate limit.
•
•
pps — The number of packets per second (Range: 0–300).
•
seconds — The number of seconds (Range: 1–15).
Default Configuration
The default rate limit is 15 packets per second.
The default burst interval is 1 second.
The default burst interval is 1 second.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.