DELL PC6224F User Manual

Page of 1356
722
IP Routing Commands
encapsulation
Use the encapsulation command in Interface Configuration mode to 
configure the link layer encapsulation type for the packet. Routed frames are 
always ethernet encapsulated when a frame is routed to a VLAN.
Syntax
encapsulation {ethernet | snap}
• ethernet — Specifies Ethernet encapsulation.
snap — Specifies SNAP encapsulation.
Default Configuration
Ethernet encapsulation is the default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example applies SNAP encapsulation for VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#encapsulation snap
ip address
Use the ip address command in Interface Configuration mode to configure 
an IP address on an interface. Also use this command to configure one or 
more secondary IP addresses on the interface. This command changes the 
label IP address in the show IP interface.
Syntax
ip address 
ip-address {subnet-mask | prefix-length} [secondary]