DELL PC6224F User Manual

OSPFv3 Commands

Hello Interval........................... 10

Dead Interval............................ 40

LSA Ack Interval......................... 1

Iftransit Delay Interval................. 1

Authentication Type...................... None

Metric Cost.............................. 10  (computed)

OSPF Mtu-ignore.......................... Disable

OSPF Interface Type...................... broadcast

State.................................... backup-

designated-router

Designated Router........................ 1.1.1.1

Backup Designated Router................. 2.2.2.2

Number of Link Events.................... 46

Use the show ipv6 ospf neighbor command in Privileged EXEC mode to 

display information about OSPF neighbors. If a neighbor IP address is not 

specified, the output displays summary information in a table. If an interface 

or tunnel is specified, only the information for that interface or tunnel 

displays. The information below only displays if OSPF is enabled and the 

interface has a neighbor.

show ipv6 ospf neighbor [ interface { vlan

 vlan-id | tunnel tunnel-id } ] [ ip-

address ]  

•

vlan-id — Valid VLAN ID.

•

tunnel-id — Tunnel identifier. (Range: 0-7)

•

ip-address — Is the valid IP address of the neighbor about which 

information is displayed.

This command has no default configuration.