DELL PC6248 User Manual
1154
PHY Diagnostics Commands
show fiber-ports optical-transceiver
Use the show fiber-ports optical-transceiver command in Privileged EXEC
mode to display the optical transceiver diagnostics.
Syntax
show fiber-ports optical-transceiver [
interface]
•
interface — A valid Ethernet port. The full syntax is unit / port.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
The show fiber ports command is only applicable to the SFP combo ports and
XFP ports (not the ports on the SFP+ plug-in module).
Examples
The following examples display the optical transceiver diagnostics.
console#show fiber-ports optical-transceiver
Port
Temp
Voltage
Current
Output
Input
TX
LOS
Power
Power
Fault
-----------
------
-------
-------
------
-----
-----
---
1/g3
w
OK
E
OK
OK
OK
OK
1/g4
OK
OK
OK
OK
OK
E
OK
1/g1
Copper
Temp - Internally measured transceiver temperature
Voltage - Internally measured supply voltage
Current - Measured TX bias current
Output Power - Measured TX output power in milliWatts
Input Power - Measured RX received power in milliWatts
TX Fault - Transmitter fault
LOS - Loss of signal