DELL PC6248 User Manual
790
IPv6 Routing Commands
Example
console(config-if-vlan5)#ipv6 pimdm hello-interval
500
ipv6 route
Use the ipv6 route command in Global Configuration mode to configure an
IPv6 static route.
Syntax
ipv6 route
ipv6-prefix /prefix-length [Null | interface {tunnel tunnel-id |
vlan
vlan-id}] next-hop-address [preference]
no ipv6 route
ipv6-prefix /prefix-length [Null | interface {tunnel tunnel-id |
vlan
vlan-id}] next-hop-address
•
ipv6-prefix — Is the IPv6 network that is the destination of the static
route.
•
prefix-length — Is the length of the IPv6 prefix — a decimal value (usually
0-64) that shows how many of the high-order contiguous bits of the
address comprise the prefix (the network portion of the address). A slash
mark must precede it.
•
interface — Identifies direct static routes from point-to-point and
broadcast interfaces, and must be specified when using a link-local address
as the next hop.
• tunnel or vlan — Is the tunnel or vlan interface to associate with the route.
•
•
next-hop-address — Is the IPv6 address of the next hop that can be used to
reach the specified network.
•
preference — Is a value the router uses to compare this route with routes
from other route sources that have the same destination. (Range: 1-255)
Default Configuration
1 is the default value for
preference.
Command Mode
Global Configuration mode