DELL S50V User Manual
System Time and Date | 1073
Set the Hardware Clock with the Time Derived from NTP
Figure 53-4. Displaying the Calculated NTP Synchronization Variables
Configure NTP broadcasts
With FTOS, you can receive broadcasts of time information. You can set interfaces within the system to
receive NTP information through broadcast.
receive NTP information through broadcast.
To configure an interface to receive NTP broadcasts, use the following commands in the INTERFACE
mode:
mode:
Disable NTP on an interface
By default, NTP is enabled on all active interfaces. If you disable NTP on an interface, FTOS drops any
NTP packets sent to that interface.
NTP packets sent to that interface.
Task
Command
Command Mode
Periodically update the system hardware clock with the time
value derived from NTP.
value derived from NTP.
ntp update-calendar
CONFIGURATION
Task
Command
Command
Set the interface to receive NTP packets.
ntp broadcast client
INTERFACE
Table 53-1.
2w1d11h : NTP: Maximum Slew:-0.000470, Remainder = -0.496884
R5/R8(conf)#do show calendar
06:31:02 UTC Mon Mar 13 1989
R5/R8(conf)#ntp update-calendar 1
R5/R8(conf)#do show calendar
06:31:26 UTC Mon Mar 13 1989
R5/R8(conf)#do show calendar
12:24:11 UTC Thu Mar 12 2009