DELL S50V User Manual

|

Force10 Service Agent

www.dell.com | support.dell.com

Line card state-change policy configuration

The following FTSA policy configuration uses the default test list hardware, which contains a 
line-card-state-change condition, and the default action list hardware plus the custom action show linecard 
4 | grep Status. Linecard 4 is then taken offline to trigger a match against the card-state-change test 
condition.

Associate a Dell Force10 TAC case number with the 
policy. Configure a case number only if you already 
have a case open with Dell Force10 for the policy. This 
case number is included in action-list messages sent to 
Dell Force10. 

case-number number

CALLHOME POLICY

Delay the subsequent execution of the test list after a 
match occurs. This configuration reduces the risk of 
burdening the CPU with sampling when a failure 
condition has already been detected.
Default: 5 minutes

dampen minutes

CALLHOME POLICY

Associate a Dell Force10 Problem Report (PR) number 
with the policy. Configure a PR number only if you 
already have a case open with Dell Force10 for the 
policy. This PR number is included in action-list 
messages sent to Dell Force10.

pr-number number

CALLHOME POLICY

Execute the action list contingent upon the state of CPU 
utilization. The CPU utilization is calculated in 
percentage using the 1 minute rolling average of all 
RPM CPUs.
Default: unconditional

{

| {

cp slot | any} | 

}

 {{less-than | 

} 

CALLHOME POLICY

Note: If a test-list match is found, but the action-list does not execute because the 

 

 condition is 

exists, then FTSA logs the test-list match and indicates that the action-list was prevented. However, if the trigger 
event was a high or specified CPU usage condition in the test-list, then the FTSA ignores the 

configuration.

Specify the interval at which the system variables 
specified in the test-list are sampled.
Default: 1 minute

CALLHOME POLICY

Execute the test list multiple times. If the test limit is 
greater than 1, the test list is executed immediately after 
the previous execution is complete.
Default: unlimited

CALLHOME POLICY