DELL S50V User Manual
![DELL](https://files.manualsbrain.com/attachments/2e2ed634a275b6b98ad69257c58632e179ac1658/common/fit/150/50/0b94a25108df4a3b962d3b8aa65fc4eda1ead8e68832a26b3f5ed6aa6a0b/brand_logo.png)
Interfaces | 455
Auto-Negotiation on Ethernet Interfaces
Setting speed and duplex mode of Ethernet Interfaces
By default, auto-negotiation of speed and duplex mode is enabled on 10/100/1000 Base-T Ethernet
interfaces. Only 10GE interfaces do not support auto-negotiation. When using 10GE interfaces, verify that
the settings on the connecting devices are set to no auto-negotiation.
interfaces. Only 10GE interfaces do not support auto-negotiation. When using 10GE interfaces, verify that
the settings on the connecting devices are set to no auto-negotiation.
The local interface and the directly connected remote interface must have the same setting, and
auto-negotiation is the easiest way to accomplish that, as long as the remote interface is capable of
auto-negotiation.
auto-negotiation is the easiest way to accomplish that, as long as the remote interface is capable of
auto-negotiation.
Note: As a best practice, Dell Force10 recommends keeping auto-negotiation enabled. Auto-negotiation
should only be disabled on switch ports that attach to devices not capable of supporting negotiation or
where connectivity issues arise from interoperability issues.
should only be disabled on switch ports that attach to devices not capable of supporting negotiation or
where connectivity issues arise from interoperability issues.
For 10/100/1000 Ethernet interfaces, the
negotiation auto
command is tied to the
speed
command.
Auto-negotiation is always enabled when the
speed
command is set to
1000
or
auto
.
To discover whether the remote and local interface require manual speed synchronization, and to manually
synchronize them if necessary, use the following command sequence (see
synchronize them if necessary, use the following command sequence (see
Note: Starting with FTOS 7.8.1.0, when a copper SFP2 module with catalog number GP-SFP2-1T is used
in the S25P model of the S-Series, its speed can be manually set with the
in the S25P model of the S-Series, its speed can be manually set with the
speed
command. When the
speed is set to 10 or 100 Mbps, the
duplex
command can also be executed.
Step
Task
Command Syntax
Command Mode
1
Determine the local interface status. See
show interfaces
[
interface
|
linecard
slot-number
]
status
EXEC Privilege
2
Determine the remote interface status.
[Use the command on the remote system
that is equivalent to the above command.]
that is equivalent to the above command.]
EXEC
EXEC Privilege
EXEC Privilege
3
Access CONFIGURATION mode.
config
EXEC Privilege
4
Access the port.
interface
interface
slot
/
port
CONFIGURATION
5
Set the local port speed.
speed
{
10
|
100
|
1000
|
auto
}
INTERFACE
6
Optionally, set full- or half-duplex.
duplex
{
half
|
full
}
INTERFACE
7
Disable auto-negotiation on the port. If the
speed was set to 1000, auto-negotiation
does not need to be disabled.
speed was set to 1000, auto-negotiation
does not need to be disabled.
no negotiation auto
INTERFACE
8
Verify configuration changes.
show config
INTERFACE