DELL S50V User Manual
System Management | 67
Synchronize Log Messages
You can configure a terminal line to hold all logs until all command inputs and outputs are complete so that
log printing does not interfere when you are performing management tasks. Log synchronization also
filters system messages for a specific line based on severity level and limits number of messages that are
printed at once.
log printing does not interfere when you are performing management tasks. Log synchronization also
filters system messages for a specific line based on severity level and limits number of messages that are
printed at once.
Display the logging synchronous configuration using the
show config
command from LINE mode.
Enable Timestamp on Syslog Messages
Syslog messages, by default, do not include a time/date stamp stating when the error or message was
created. To have FTOS include a timestamp with the syslog message:
created. To have FTOS include a timestamp with the syslog message:
Display your configuration using the command
show running-config logging
from EXEC Privilege
mode, as shown in
Step
Task
Command Syntax
Command Mode
1
Enter the LINE mode. Configure the
following parameters for the virtual
terminal lines:
following parameters for the virtual
terminal lines:
•
number
range: zero (0) to 8.
•
end-number
range: 1 to 8.
You can configure multiple virtual
terminals at one time by entering a
terminals at one time by entering a
number
followed by an
end-number.
line
{
console 0
|
vty
number
[
end-number
] |
aux 0
}
CONFIGURATION
2
Set a level and the maximum number of
messages to be printed. The following
parameters are optional:
messages to be printed. The following
parameters are optional:
•
level
severity-level
range: 0 to 7.
Default is 2. Use the
all
keyword to
include all messages.
•
limit
range: 20 to 300. Default is 20.
logging synchronous
[
level
severity-level
|
all
] [
limit
]
LINE
Purpose
Command Syntax
Command Mode
Add timestamp to syslog messages. Specify
the following optional parameters:
the following optional parameters:
•
datetime
: You can add the keyword
localtime to include the
localtime, msec,
and
show-timezone
. If you do not add
the keyword
localtime
, the time is UTC.
•
uptime
. To view time since the last boot.
service timestamps
[
log | debug
]
[
datetime
[
localtime
] [
msec
] [
show-timezone
] |
uptime
]
Default: uptime
CONFIGURATION