DELL S50V User Manual

|

Object Tracking

www.dell.com | support.dell.com

To configure object tracking on the status of a Layer 2 interface, use the following commands. To remove 
object tracking on a Layer 2 interface, enter the 

no track object-id 

command. 

You can create an object that tracks the routing status of an IPv4 or IPv6 Layer 3 interface. You can track 
the routing status of any of the following Layer 3 interfaces:

•

1-Gigabit Ethernet: Enter 

 

 in the 

 

command (see Step 1 

below).

•

10-Gigabit Ethernet: Enter 

 

.

•

Port channel: Enter 

 

, where valid port-channel numbers are:

•

For the C-Series and S-Series, 1 to 128

•

For the E-Series, 1 to 32 (EtherScale) and 1 to 255 (TeraScale and ExaScale)

•

SONET: Enter 

sonet slot/port

.

•

VLAN: Enter 

 

, where valid VLAN IDs are from 1 to 4094.

1

Configure object tracking on the 
line-protocol state of a Layer 2 interface.

interface interface 

Valid object IDs are from 1 to 65535.

CONFIGURATION

2

(Optional) Configure the time delay used 
before communicating a change in the 
status of a tracked interface.

{[

 

] [

 

]}

Valid delay times are from 0 to 180 
seconds. Default: 0.

OBJECT TRACKING

3

(Optional) Identify the tracked object 
with a text description.

 

The text string can be up to 80 
characters.

OBJECT TRACKING

4

(Optional) Display the tracking 
configuration and the tracked object’s 
status.

EXEC Privilege

FTOS(conf)#track 100 interface gigabitethernet 7/1 line-protocol

FTOS(conf-track-100)#delay up 20

FTOS(conf-track-100)#description San Jose data center

FTOS(conf-track-100)#end

FTOS#show track 100

Track 100

  Interface GigabitEthernet 7/1 line-protocol

  Description: San Jose data center

  Line protocol is Up

   2 changes, last change 00:03:05

  Tracked by: