DELL S50V User Manual
Open Shortest Path First (OSPFv2 and OSPFv3) | 715
shows
settings when fast-convergence is disabled. These displays appear with the
show ip ospf
command.
Figure 32-14. Command Example:
show ip ospf
process-id
(fast-convergence enabled
)
Figure 32-15. Command example:
show ip ospf
process-id
(fast-convergence disabled)
Change OSPFv2 parameters on interfaces
In FTOS, you can modify the OSPF settings on the interfaces. Some interface parameter values must be
consistent across all interfaces to avoid routing errors. For example, you must set the same time interval for
the hello packets on all routers in the OSPF network to prevent misconfiguration of OSPF neighbors.
consistent across all interfaces to avoid routing errors. For example, you must set the same time interval for
the hello packets on all routers in the OSPF network to prevent misconfiguration of OSPF neighbors.
FTOS(conf-router_ospf-1)#fast-converge 2
FTOS(conf-router_ospf-1)#ex
FTOS(conf)#ex
FTOS#show ip ospf 1
Routing Process ospf 1 with ID 192.168.67.2
Supports only single TOS (TOS0) routes
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
Convergence Level 2
Min LSA origination 0 secs, Min LSA arrival 0 secs
Number of area in this router is 0, normal 0 stub 0 nssa 0
FTOS#
Fast-converge parameter
setting
setting
LSA Parameters
FTOS#(conf-router_ospf-1)#no fast-converge
FTOS#(conf-router_ospf-1)#ex
FTOS#(conf)#ex
FTOS##show ip ospf 1
Routing Process ospf 1 with ID 192.168.67.2
Supports only single TOS (TOS0) routes
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
Convergence Level 0
Min LSA origination 5 secs, Min LSA arrival 1 secs
Number of area in this router is 0, normal 0 stub 0 nssa 0
FTOS#
setting
LSA Parameters
Fast-converge parameter