DELL S50V User Manual
Policy-based Routing | 805
Create a Rule for a Redirect-list
Use the following command in CONFIGURATION REDIRECT-LIST mode to set the rules for the
redirect list. You can enter the command multiple times and create a sequence of redirect rules. Use the
redirect list. You can enter the command multiple times and create a sequence of redirect rules. Use the
seq
nn
redirect
version of the command to organize your rules
.
•
IP address of the next-hop router in the forwarding route
•
IP protocol number
•
Source address with mask information
•
Destination address with mask information.
Command Syntax
Command
Mode
Mode
Purpose
seq
{number}
redirect
{
ip-address
|
sonet
}
{
ip-protocol-number
|
protocol-type
[
bit
]}
{
source mask
|
any
|
host
ip-address
}
{
destination mask
|
any
|
host
ip-address
}
CONF-
REDIRECT-
LIST
REDIRECT-
LIST
Configure a rule for the redirect list.
number is the number in sequence to initiate this
rule
ip-address is the Forwarding router’s address
rule
ip-address is the Forwarding router’s address
FORMAT: A.B.C.D
sonet is a sonet interface
FORMAT:
sonet
slot/port
ip-protocol-number
or
protocol-type is the type of
protocol to be redirected
FORMAT: 0-255 for IP protocol number, or
enter protocol type
source ip-address or any
or
host
ip-address is the
Source’s IP address
FORMAT: A.B.C.D/NN, or ANY or HOST IP
address
destination ip-address or any
or
host
ip-address
is the Destination’s IP address
FORMAT: A.B.C.D/NN, or ANY or HOST IP
address
Delete a rule with the
no redirect
command.
The redirect rule supports
Destination router IP address