DELL 200S User Manual

support.dell.com

 To install the component mounting bracket, perform the following steps:

1.

Carefully insert the component mounting bracket into the back of the storage 
system.

2.

Slowly slide the bracket all the way into the housing. 

Some up-down and side-to-side motion may be necessary to slide the bracket in. 
Ensure that the center guide tab at the bottom of the housing goes into the slot 
on the center support of the component mounting bracket.

3.

Insert the two screws and, using a Phillips-head screwdriver, tighten the screws 
to secure the component mounting bracket to the chassis.

4.

Reinstall the power supplies (see "Replacing the Power Supply," found earlier in 
this chapter) and cooling fans (see "Replacing a Cooling Fan," found earlier in this 
chapter).

" $!$!

To remove the dual-bus split backplane module, perform the following steps:

1.

Remove all power supplies from the back of the storage system (see "Replacing 
the Power Supply," found earlier in this chapter).

2.

Remove all cooling fans from the back of the storage system (see "Replacing a 
Cooling Fan," found earlier in this chapter).

3.

Remove the enclosure module(s) (see "Replacing an Enclosure Module," found 
earlier in this chapter).

4.

Remove the component mounting bracket (see "Removing and Reinstalling the 
Component Mounting Bracket," found earlier in this chapter).

5.

Using both hands, carefully hold the dual-bus split backplane module on both 
sides and, using a wiggle motion, pull the module from the backplane board (see 
Figure 7-10).