D-Link DGS-3224TGR User Manual

54 

Select the port you want port error packet statistics for from the drop-down menu. 

Select the desired setting between 2 seconds and 60 seconds or Suspend. 

Clicking this button clears all statistics counters on this window. 

Counts otherwise valid frames that did not end on a byte (octet) boundary. 

The number of frames detected that are less than the minimum permitted frame size of 64 
bytes and have a good CRC. Undersize frames usually indicate collision fragments, a 
normal network occurrence. 

Counts packets received that were longer than 1518 octets, or if a VLAN frame 1522 
octets, and less than the MAX_PKT_LEN. Internally, MAX_PKT_LEN is equal to 1522. 

The number of packets less than 64 bytes with either bad framing or an invalid CRC. 
These are normally the result of collisions. 

The number of frames with lengths more than the MAX_PKT_LEN bytes. Internally, 
MAX_PKT_LEN is equal to 1522. 

The number of frames that are dropped by this port since the last Switch reboot. 

Counts the number of frames for which the first transmission attempt on a particular 
interface was delayed because the medium was busy. 

For 10 Mbps ports, the counter records CRC errors (FCS or alignment errors). For 100 
Mbps ports, the counter records the sum of CRC errors and code errors (frames received 
with rxerror signal). 

Counts the number of times that a collision is detected later than 512 bit-times into the 
transmission of a packet. 

The number of frames for which transmission failed due to excessive collisions. 

The number of successfully transmitted frames for which transmission is inhibited by more 
than one collision. 

An estimate of the total number of collisions on this network segment. 

 

The information is described as follows: