DELL 3324 User Manual
C o n f i g u r i n g t h e Po w e r C o n n e c t 3 3 2 4 / 3 3 4 8 S w i t c h
53
To configure SNMP station IP address and community string(s):
1
At the console prompt, type Enable. The prompt is displayed as #.
2
Type configure and press <Enter>.
3
In the configuration mode, type the SNMP configuration command with the
parameters including community name (private), community access right (read and
write) and IP address, as shown in the example below:
parameters including community name (private), community access right (read and
write) and IP address, as shown in the example below:
console> enable
config# configure
config(config)# snmp-server community private rw 11.1.1.2
config(config)# exit
config# show snmp
Community-String
Community-Access
IP address
--------------------
----------------
---------------
private
readWrite
11.1.1.2
Traps are enabled.
Authentication-failure trap is enabled.
Trap-Rec-Address
Trap-Rec-Community
Version
----------------
--------------------
-------
System Contact:
System Location:
This completes the initial configuration of the device from a local terminal. The configured
parameters enable further device configuration from any remote location.
parameters enable further device configuration from any remote location.
Advanced Configuration
This chapter contains information about dynamic allocation of IP addresses and security
management based on the AAA (authentication, authorization and accounting)
mechanism. The chapter includes the following topics:
management based on the AAA (authentication, authorization and accounting)
mechanism. The chapter includes the following topics:
•
Configuring IP Addresses through DHCP.
•
Configuring IP Addresses through BOOTP.
•
Security Management and Password Configuration.