DELL 6024 User Manual
Configuring System Information
121
Defining SNTP Interface Settings Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the
SNTP Broadcast Interface Table.
SNTP Broadcast Interface Table.
NOTE:
When defining Anycast or Broadcast interfaces, at least one IP address must be defined.
The following is an example of the CLI commands for configuring SNTP interfaces:
Table 6-8.
SNTP interface Settings CLI Commands
CLI Command
Description
sntp client enable
Enables the Simple Network Time Protocol
(SNTP) broadcast and anycast client on an
interface.
(SNTP) broadcast and anycast client on an
interface.
show sntp
configuration
Displays the SNTP configuration.
Console (config)#
interface
ethernet g1
Console (config-if)#
sntp client enable
Console (config-if)#
end
Console#
show sntp configuration
Polling interval: 7200 seconds.
MD5 Authentication keys: 8, 9
Authentication is required for synchronization.
Trusted Keys: 8,9
Unicast Clients Polling: Enabled.
Server
Polling
Encryption Key
-----------
--------
-----------------
176.1.1.8
Enabled
9
176.1.8.179
Disabled
Disabled
Broadcast Clients: Enabled
Broadcast Clients Poll: Enabled
Broadcast Interfaces: g1