DELL 6024 User Manual
360
Configuring Routing
www
.dell.com | support.dell.com
The following is an example of the CLI commands:
Console (config)# show ip ospf virtual-links
Virtual Link to router 192.168.101.2 is up
Virtual link has simple password authentication
Transit area 0.0.0.1
Transmit Delay is 1 sec, State POINT_TO_POINT
Timer intervals configured, Hello 10, Dead 40, Retransmit 5
Adjacency State FULL
Console (config)#router ospf area 176.16.1.0 virtual-link
176.16.8.7
Console (config)#router ospf area 176.16.1.0 virtual-link
176.16.8.7
Configuring OSPF Interface Parameters
After OSPF global parameters and areas are defined, you can configure OSPF on each interface.
Auto-creation allows OSPF to be configured automatically on each interface after an area is
defined. OSPF interfaces can also be user-defined. The OSPF Interface table enables IP routing
using OSPF specific information.
To display the Interface Parameters page, click Router
Auto-creation allows OSPF to be configured automatically on each interface after an area is
defined. OSPF interfaces can also be user-defined. The OSPF Interface table enables IP routing
using OSPF specific information.
To display the Interface Parameters page, click Router
→ OSPF→ Interface Parameters in the tree
view.