DELL 9.8(0.0) User Manual
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.3.11.1
Introduced on the Z9000.
7.5.1.0
Introduced on the E-Series.
Usage
Information
Information
To perform protocol-support consistency checks on hello packets, use this
command. The adjacency-check is enabled by default.
If a BFD session goes down indicating that IPv4 or IPv6 connectivity to its neighbor
is lost, it does not imply that the adjacency is lost altogether. The hello adjacency
runs over Layer 2, and does not require IP connectivity. However, if IPv4
connectivity is lost to a neighbor, then when the next SPF calculation is performed,
the system ensures that it does not calculate any IPv4 or IPv6 routes through that
neighbor.
command. The adjacency-check is enabled by default.
If a BFD session goes down indicating that IPv4 or IPv6 connectivity to its neighbor
is lost, it does not imply that the adjacency is lost altogether. The hello adjacency
runs over Layer 2, and does not require IP connectivity. However, if IPv4
connectivity is lost to a neighbor, then when the next SPF calculation is performed,
the system ensures that it does not calculate any IPv4 or IPv6 routes through that
neighbor.
advertise
Leak routes between levels (distribute IP prefixes between Level 1 and Level 2 and vice versa).
Syntax
advertise {level1-into-level2 | level2-into-level1} prefix-
list-name
To return to the default, use the no advertise {level1-into-level2 |
level2-into-level1}[prefix-list-name] command.
list-name
To return to the default, use the no advertise {level1-into-level2 |
level2-into-level1}[prefix-list-name] command.
Parameters
level1-into-
level2
level2
Enter the keywords level1-into-level2 to advertise
Level 1 routes into Level 2 LSPs. This setting is the default.
Level 1 routes into Level 2 LSPs. This setting is the default.
level2-into-
level1
level1
Enter the keywords level2-into-level1 to advertise
Level 2 inter-area routes into Level 1 LSPs. This behavior is
described in RFC 2966.
Level 2 inter-area routes into Level 1 LSPs. This behavior is
described in RFC 2966.
prefix-list-
name
name
Enter the name of a configured IP prefix list. Routes meeting
the criteria of the IP Prefix list are leaked.
the criteria of the IP Prefix list are leaked.
Defaults
level1-into-level2 (Level 1 to Level 2 leaking is enabled.)
level2–into-level1 (Level 2 to Level 1) leaking is disabled.
level2–into-level1 (Level 2 to Level 1) leaking is disabled.
Command
Modes
Modes
• ROUTER ISIS (for IPv4)
Intermediate System to Intermediate System (IS-IS)
1025