DELL 9.8(0.0) User Manual
Command
Modes
Modes
INTERFACE
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
pre- 6.1.1.1
Introduced on the E-Series.
Usage
Information
Information
Setting a priority of 0 makes the router ineligible for election as a designated router
or backup designated router.
or backup designated router.
Use this command for interfaces connected to multi-access networks, not point-
to-point networks.
to-point networks.
ip ospf retransmit-interval
Set the retransmission time between lost link state advertisements (LSAs) for adjacencies belonging to the
interface.
S4820T
Syntax
ip ospf retransmit-interval seconds
To return to the default values, use the no ip ospf retransmit-interval
command.
To return to the default values, use the no ip ospf retransmit-interval
command.
Parameters
seconds
Enter the number of seconds as the interval between
retransmission. The range is from 1 to 3600. The default is 5
seconds.
This interval must be greater than the expected round-trip
time for a packet to travel between two routers.
retransmission. The range is from 1 to 3600. The default is 5
seconds.
This interval must be greater than the expected round-trip
time for a packet to travel between two routers.
Defaults
5 seconds
Open Shortest Path First (OSPFv2 and OSPFv3)
1291