DELL 9.8(0.0) User Manual
• TenGigabitEthernet—Default cost is 1
• FortygigEthernet — Default cost is 1
• Ethernet—Default cost is 10
• FortygigEthernet — Default cost is 1
• Ethernet—Default cost is 10
ipv6 ospf dead-interval
Set the time interval since the last hello-packet was received from a router. After the time interval elapses,
the neighboring routers declare the router down.
the neighboring routers declare the router down.
S4820T
Syntax
ipv6 ospf dead-interval seconds
To return to the default time interval, use the no ipv6 ospf dead-interval
command.
To return to the default time interval, use the no ipv6 ospf dead-interval
command.
Parameters
seconds
Enter the time interval in seconds. The range is from 1 to
65535 seconds.
65535 seconds.
Defaults
40 seconds (Ethernet).
Command
Modes
Modes
INTERFACE
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.1.(0.0)
Introduced on the S4810 and Z9000.
7.8.1.0
Added support for C-Series.
7.4.1.0
Introduced on the E-Series.
8.3.19.0
Introduced on the S4820T.
Usage
Information
Information
By default, the dead interval is four times longer than the default hello-interval.
Related
Commands
Commands
Open Shortest Path First (OSPFv2 and OSPFv3)
1359