DELL 9.8(0.0) User Manual
42
PIM-Sparse Mode (PIM-SM)
The protocol-independent multicast (PIM) commands are supported by the Dell Networking operating
software on the platform.
software on the platform.
IPv4 PIM-Sparse Mode Commands
The following describes the IPv4 PIM-sparse mode (PIM-SM) commands.
clear ip pim rp-mapping
The bootstrap router (BSR) feature uses this command to remove all or particular rendezvous point (RP)
advertisement.
S4820T
Syntax
clear ip pim [vrf vrf-name] rp-mapping [rp-address]
Parameters
vrf vrf-name
(OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to configure this setting on that VRF.
the VRF to configure this setting on that VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
applies to Default VRF.
rp-address
(OPTIONAL) Enter the RP address in dotted decimal format
(A.B.C.D).
(A.B.C.D).
Command
Modes
Modes
EXEC Privilege
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Added support for VRF. Introduced on the S6000-ON.
9.5(0.1)
Introduced on the Z9500.
PIM-Sparse Mode (PIM-SM)
1391