DELL 9.8(0.0) User Manual
tc-flush-standard
Enable the MAC address flushing after receiving every topology change notification.
S4820T
Syntax
tc-flush-standard
To disable, use the no tc-flush-standard command.
To disable, use the no tc-flush-standard command.
Defaults
Disabled.
Command
Modes
Modes
CONFIGURATION
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
6.5.1.0
Introduced.
Usage
Information
Information
By default, Dell Networking OS implements an optimized flush mechanism for
PVST+. This implementation helps in flushing the MAC addresses only when
necessary (and less often) allowing for faster convergence during topology
changes. However, if a standards-based flush mechanism is needed, you can turn
this knob command on to enable flushing MAC addresses after receiving every
topology change notification.
PVST+. This implementation helps in flushing the MAC addresses only when
necessary (and less often) allowing for faster convergence during topology
changes. However, if a standards-based flush mechanism is needed, you can turn
this knob command on to enable flushing MAC addresses after receiving every
topology change notification.
Per-VLAN Spanning Tree Plus (PVST+)
1453