DELL 9.8(0.0) User Manual
protocol spanning-tree rstp
To configure RSTP, enter RSTP mode.
Syntax
protocol spanning-tree rstp
To exit RSTP mode, use the exit command.
To exit RSTP mode, use the exit command.
Defaults
Not configured
Command
Modes
Modes
CONFIGURATION
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
6.2.1.1
Introduced on the E-Series.
Usage
Information
Information
RSTP is not enabled when you enter RSTP mode. To enable RSTP globally on the
system, use the no disable command from RSTP mode.
system, use the no disable command from RSTP mode.
Example
Dell(conf)#protocol spanning-tree rstp
Dell(config-rstp)##no disable
Related
Commands
Commands
Rapid Spanning Tree Protocol (RSTP)
1565