DELL 9.8(0.0) User Manual
Version
Description
E-Series legacy
command
command
Usage
Information
Information
To block a type of message parameter, set the logging trap level to a lower
number. For example, to block severity messages at level 6, set the level to 5.
number. For example, to block severity messages at level 6, set the level to 5.
Related
Commands
Commands
logging version
Displays syslog messages in a RFC 3164 or RFC 5424 format.
Syntax
logging version {0|1}
Defaults
0
Command
Modes
Modes
CONFIGURATION
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
9.5(0.0)
Introduced on the S4810, S4820T, S6000, Z9000, and MXL.
Usage
Information
Information
To display syslog messages in a RFC 3164 or RFC 5424 format, use the log version
command in configuration mode. By default, the system log version is set to 0.
command in configuration mode. By default, the system log version is set to 0.
The following describes the two supported log messages formats:
• 0 – Displays syslog messages format as described in RFC 3164, The BSD syslog
Protocol
• 1 – Displays SYSLOG message format as described in RFC 5424, The Syslog
Protocol
Example
Dell(conf)#logging version ?
<0-1> Select syslog version (default = 0)
Dell(conf)#logging version 1
1736
Simple Network Management Protocol (SNMP) and Syslog