Manualsbrain.com
  1. Manuals
  2. Brands
  3. DELL
  4. 9.8(0.0)
  5. User Manual

DELL 9.8(0.0) User Manual

Download
Page of 1910
To disable storm-control for multicast traffic into the network, use the no storm-
control multicast packets_per_second in command.
Parameters
packets_per_se
cond in
Enter the packets per second of multicast traffic allowed into 
the network. The range is from 0 to 33554368.
Defaults
none
Command 
Modes
CONFIGURATION (conf)
Command 
History
This guide is platform-specific. For command information about other platforms, 
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
9.2(0.0)
Introduced on the M I/O Aggregator. This command is 
supported in Programmable-Mux (PMUX) mode only.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.6.1.0
Introduced on the C-series and S-Series.
Usage 
Information
Broadcast traffic (all 0xFs) should be counted against the broadcast storm control 
meter, not against the multicast storm control meter. It is possible, however, that 
some multicast control traffic may get dropped when storm control thresholds are 
exceeded.
storm-control multicast (Interface)
Configure the percentage of multicast traffic allowed on an C-Series or S-Series interface (ingress only) 
network only.
Syntax
storm-control multicast packets_per_second in
To disable multicast storm control on the interface, use the no storm-control 
multicast packets_per_second in command.
Storm Control
1765