DELL 9.8(0.0) User Manual
58
Spanning Tree Protocol (STP)
The commands in this chapter configure and monitor the IEEE 802.1d spanning tree protocol (STP) and
are supported on the Dell Networking switch/routing platform.
are supported on the Dell Networking switch/routing platform.
bridge-priority
Set the bridge priority of the switch in an IEEE 802.1D spanning tree.
Syntax
bridge-priority {priority-value | primary | secondary}
To return to the default value, use the no bridge-priority command.
To return to the default value, use the no bridge-priority command.
Parameters
priority-value
Enter a number as the bridge priority value. The range is
from 0 to 65535. The default is 32768.
from 0 to 65535. The default is 32768.
primary
Enter the keyword primary to designate the bridge as the
root bridge.
root bridge.
secondary
Enter the keyword secondary to designate the bridge as a
secondary root bridge.
secondary root bridge.
Defaults
priority-value = 32768
Command
Modes
Modes
SPANNING TREE (The prompt is “config-stp”.)
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
Spanning Tree Protocol (STP)
1769