DELL 9.8(0.0) User Manual

Configuration of IPv6 commands over decapsulate-any tunnel causes an error.

tunnel source

Set a source address for the tunnel.

Syntax

tunnel source {ip-address | ipv6–address | interface-type-
number | anylocal}
To delete the current tunnel source address, use the no tunnel source 
command.

Parameters

Enter the source IPv4 address in A.B.C.D format.

Enter the source IPv6 address in X:X:X:X::X format.

• For a port channel interface, enter the keywords port-

channel then a number from 1 to 128.

• For a 10-Gigabit Ethernet interface, enter the keyword 

TenGigabitEthernet then the slot/port information.

• For a 40-Gigabit Ethernet interface, enter the keyword 

fortyGigE then the slot/port information.

• For a VLAN interface, enter the keyword vlan then a 

number from 1 to 4094.

Enter the anylocal command to allow the multipoint 
receive-only tunnel to decapsulate tunnel packets destined 
to any local ip address.

Defaults

none

Command 
Modes

INTERFACE TUNNEL (conf-if-tu)

Command 
History

Version

Description

9.7(0.0)

Introduced on the S6000-ON.

9.5(0.1)

Introduced on the Z9500.

9.4(0.0)

Added the tunnel source anylocal command.

9.3(0.0)

Introduced on the S4810, S4820T, S6000 and Z9000.

Usage 
Information

Added an optional keyword “anylocal” to the tunnel source command.  The 
anylocal argument can be used in place of the ip address or interface, but only with 
the multipoint receive-only mode tunnels. The tunnel source anylocal command 

1816

Tunneling