DELL 9.8(0.0) User Manual
Version
Description
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.4.2.3
Introduced on the S-Series S50.
Related
Commands
Commands
•
— assigns a port or port-channel to the uplink-state group as a
downstream interface.
•
upstream links.
debug uplink-state-group
Enable debug messages for events related to a specified uplink-state group or all groups.
S4820T
Syntax
debug uplink-state-group [group-id]
To turn off debugging event messages, enter the no debug uplink-state-
group [group-id] command.
To turn off debugging event messages, enter the no debug uplink-state-
group [group-id] command.
Parameters
group-id
Enables debugging on the specified uplink-state group. The
valid group-id values are from 1 to 16.
valid group-id values are from 1 to 16.
Defaults
none
Command
Modes
Modes
EXEC Privilege
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
supported in Programmable-Mux (PMUX) mode only.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.4.2.3
Introduced on the S-Series S50.
Uplink Failure Detection (UFD)
1819