DELL 9.8(0.0) User Manual
Defaults
Not configured.
Command
Modes
Modes
VLT DOMAIN
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
9.5(0.1)
Introduced on the Z9500.
9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0
Introduced on the S6000.
9.0.0.0
Introduced on the Z9000.
8.3.19.0
Introduced on the S8420T.
8.3.12.0
Introduced on the S4810.
Usage
Information
Information
To delay the system from bringing up the VLT port for a brief period to allow IGMP
Snooping and Layer 3 routing protocols to converge, use the delay-restore
parameter. Use this feature:
Snooping and Layer 3 routing protocols to converge, use the delay-restore
parameter. Use this feature:
• after a VLT device is reloaded.
• if the Peer VLT device was up at the time the VLTi link failed to the time when it
• if the Peer VLT device was up at the time the VLTi link failed to the time when it
was restored.
Related
Commands
Commands
delay-restore abort-threshold
Increase the Boot Up timer to some value (>60 seconds).
Syntax
delay-restore abort-threshold <interval>
To remove use the no delay-restore abort-threshold command.
To remove use the no delay-restore abort-threshold command.
Defaults
60 seconds
Command
Modes
Modes
VLT DOMAIN
Virtual Link Trunking (VLT)
1845