DELL 9.8(0.0) User Manual

Version

Description

9.2(0.0)

Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.

9.0.2.0

Introduced on the S6000.

9.0.0.0

Introduced on the Z9000.

8.3.19.0

Introduced on the S4820T.

8.3.8.0

Introduced on the S4810.

Usage
Information

The VLT domain ID must be the same between the two VLT devices. If the domain
ID is not the same, a syslog message is generated and VLT does not launch.

Related
Commands

show vlt

— uses the show vlt brief command to display the delay-restore

value.

vlt-peer-lag port-channel

Associate the port channel to the corresponding port channel in the VLT peer for the VLT connection to

an attached device.

Syntax

vlt-peer-lag port-channel id-number

Parameters

id-number

Enter the respective vlt port-channel number of the peer
device. The range is from 1 to 128.

Defaults

Not configured.

Command
Modes

INTERFACE PORT-CHANNEL

Command
History

This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version

Description

9.7(0.0)

Introduced on the S6000-ON.

9.5(0.1)

Introduced on the Z9500.