DELL 9.8(0.0) User Manual

Page of 1910
Example
Dell(conf-if-te-1/1-vrid-100)#version ?
2                       VRRPv2
3                       VRRPv3
both                    Interoperable, send VRRPv3 receive 
both                      
Dell(conf-if-te-1/1-vrid-100)#version 3
virtual-address
Configure up to 12 IP addresses of virtual routers in the VRRP group. To start sending VRRP packets, set at 
least one virtual address for the VRRP group.
Syntax
virtual-address ip-address1 [... ip-address12]
To delete one or more virtual IP addresses, use the no virtual-address ip-
address1
 [... ip-address12] command.
Parameters
ip-address1
Enter an IP address of the virtual router in dotted decimal 
format. The IP address must be on the same subnet as the 
interface’s primary IP address.
... ip-address12
(OPTIONAL) Enter up to 11 additional IP addresses of virtual 
routers in dotted decimal format. Separate the IP addresses 
with a space. The IP addresses must be on the same subnet 
as the interface’s primary IP address.
Defaults
Not configured.
Command 
Modes
VRRP
Command 
History
This guide is platform-specific. For command information about other platforms, 
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
7.4.1.0
Introduced support for telnetting to the VRRP group IP 
address assigned using this command.
Virtual Router Redundancy Protocol (VRRP)
1901