Manualsbrain.com
  1. Manuals
  2. Brands
  3. DELL
  4. 9.8(0.0)
  5. User Manual

DELL 9.8(0.0) User Manual

Download
Page of 1910
Common IP ACL Commands
The following commands are available within both Ingress and Egress IP ACL modes (Standard and 
Extended) and do not have mode-specific options. When an ACL is created without a rule and then is 
applied to an interface, ACL behavior reflects an implicit permit.
The platform supports both Ingress and Egress IP ACLs.
NOTE: Also refer to the 
access-class
Apply a standard ACL to a terminal line.
Syntax
access-class access-list-name [ipv4 | ipv6]
To remove an ACL, use the no access-class access-list-name [ipv4 | 
ipv6] command.
Parameters
access-list-
name
Enter the name of a configured Standard ACL, up to 140 
characters.
ipv4
Enter the keyword ipv4 to configure an IPv4 access class.
ipv6
Enter the keyword ipv6 to configure an IPv6 access class.
Defaults
Not configured.
Command 
Modes
LINE
Command 
History
This guide is platform-specific. For command information about other platforms, 
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.8(0.0)
Added the ipv4 and ipv6 parameters to the command. 
Introduced on the S3048-ON and S4048-ON.
9.7(0.0)
Introduced on the S6000–ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.1.1.0
Introduced on the E-Series ExaScale.
7.8.1.0
Increase the name string to accept up to 140 characters. 
Prior to 7.8.1.0, names were up to 16 characters long.
224
Access Control Lists (ACL)