DELL 9.8(0.0) User Manual

The number of entries allowed per ACL is hardware-dependent. For detailed 
specifications on entries allowed per ACL, refer to your line card documentation.

Example

Dell(conf)#ip access-list standard TestList

Dell(config-std-nacl)#

Related 
Commands

 — displays the current configuration.

permit

To permit packets from a specific source IP address to leave the switch, configure a filter.

Syntax

permit {source [mask]| any | host ip-address} [no-drop]
To remove this filter, you have two choices:

• Use the no seq sequence-number command if you know the filter’s 

sequence number.

• Use the no permit {source [mask] | any | host ip-address} 

command.

Parameters

Enter the IP address in dotted decimal format of the network 
from which the packet was sent.

(OPTIONAL) Enter a network mask in /prefix format (/x) or 
A.B.C.D. The mask, when specified in A.B.C.D format, may be 
either contiguous or non-contiguous.

any

Enter the keyword any to specify that all routes are subject 
to the filter. You can enter any of the following keywords to 
specify route types.

• bytes — Enter the keyword bytes to count bytes 

processed by the filter.

• count — Enter the keyword count to count packets the 

filter processes.

• dscp — Enter the keyword dcsp to match to the IP 

DCSCP values.

• fragments — Enter the keyword fragments to match 

to non-initial fragments of a datagram.

• order — Enter the keyword order to specify the QoS 

priority for the ACL entry. The range is from 0 to 254 

(where 0 is the highest priority and 254 is the lowest; 

lower-order numbers have a higher priority). If you do 

not use the keyword order, the ACLs have the lowest 

order by default (255).

host ip-address

Enter the keyword host then the IP address to specify a host 
IP address or hostname.

Access Control Lists (ACL)

233