DELL 9.8(0.0) User Manual
Version
Description
pre-6.1.1.0
Introduced on the E-Series.
Related
Commands
Commands
— specifies the OSPF area for route redistribution.
— specifies the metric value assigned to redistributed routes.
set weight
To add a non-RFC compliant attribute to the BGP route to assist with route selection, configure a filter.
Syntax
set weight weight
To delete a weight specification, use the no set weight weight command.
To delete a weight specification, use the no set weight weight command.
Parameters
weight
Enter a number as the weight used by the route meeting the
route map specification. The range is from 0 to 65535. The
default is router-originated = 32768 and all other routes = 0.
When there are multiple routes to the same destination, the
routes with a higher weight are preferred.
route map specification. The range is from 0 to 65535. The
default is router-originated = 32768 and all other routes = 0.
When there are multiple routes to the same destination, the
routes with a higher weight are preferred.
Defaults
router-originated = 32768; all other routes = 0
Defaults
Not configured.
Command
Modes
Modes
ROUTE-MAP
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000–ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.1.1.0
Introduced on the E-Series ExaScale.
316
Access Control Lists (ACL)