DELL 9.8(0.0) User Manual
seq arp (for Extended MAC ACLs)
Configure an egress filter with a sequence number that filters ARP packets meeting this criteria. This
command is supported only on 12-port GE line cards with SFP optics. For specifications, refer to your line
card documentation.
command is supported only on 12-port GE line cards with SFP optics. For specifications, refer to your line
card documentation.
NOTE: Only the options that have been newly introduced in Release 9.3(0.0) and Release 9.4(0.0)
are described here. For a complete description on all of the keywords and variables that are
available with this command, refer the topic of this command discussed earlier in this guide.
are described here. For a complete description on all of the keywords and variables that are
available with this command, refer the topic of this command discussed earlier in this guide.
Syntax
seq sequence-number {deny | permit} arp {destination-mac-
address mac-address-mask | any} vlan vlan-id {ip-address | any
| opcode code-number} [count [byte]] [order] [log [interval
minutes] [threshold-in-msgs [count]] [monitor]
To remove this filter, use the no seq sequence-number command.
address mac-address-mask | any} vlan vlan-id {ip-address | any
| opcode code-number} [count [byte]] [order] [log [interval
minutes] [threshold-in-msgs [count]] [monitor]
To remove this filter, use the no seq sequence-number command.
Parameters
log
(OPTIONAL) Enter the keyword log to enable the triggering
of ACL log messages.
of ACL log messages.
threshold-in
msgs count
msgs count
(OPTIONAL) Enter the threshold-in-msgs keyword
followed by a value to indicate the maximum number of ACL
logs that can be generated, exceeding which the generation
of ACL logs is terminated. with the seq, permit, or deny
commands. You can enter a threshold in the range of 1-100.
followed by a value to indicate the maximum number of ACL
logs that can be generated, exceeding which the generation
of ACL logs is terminated. with the seq, permit, or deny
commands. You can enter a threshold in the range of 1-100.
interval
minutes
minutes
(OPTIONAL) Enter the keyword interval followed by the
time period in minutes at which ACL logs must be generated.
You can enter an interval in the range of 1-10 minutes.
time period in minutes at which ACL logs must be generated.
You can enter an interval in the range of 1-10 minutes.
monitor
(OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the monitored
interface.
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the monitored
interface.
Defaults
By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is 5 minutes. By default,
flow-based monitoring is not enabled.
flow-based monitoring is not enabled.
Command
Modes
Modes
CONFIGURATION-EXTENDED-ACCESS-LIST
Command
History
History
Version
Description
9.7(0.0)
Introduced on the S6000–ON.
9.4(0.0)
Added support for flow-based monitoring on the S4810,
S4820T, S6000, Z9000, and MXL 10/40GbE Switch IO
Module platforms.
S4820T, S6000, Z9000, and MXL 10/40GbE Switch IO
Module platforms.
Access Control Lists (ACL)
353